MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
148
ariable or Attribute Default Value
STP capabilities Disabled
reconfiguring general operation priorit
32768
Bridge maximum age 20 seconds
Hello
ime 2 seconds
Forward dela
15 seconds
econfiguring per-port STP path cos
0
Priorit
32768
Mode Normal
Monitoring of STP Not Available
Root Por
Not se
Figure 82 – STP default values – refer to next section “Using STP” for more detailed explanation on
the variables
1. By default, STP is disabled. To use STP, it has to be manually
enabled
2. If you are using tagged VLANs, at least one untagged VLAN must
be available for the BPDU’s to propagate through the network to update
STP status
3. Whenever changes are made to STP, it is recommended to disable
and enable STP to ensure the changes are effective
Using STP
The commands used for configuring STP are listed below.
Syntax
show stp <config|ports > - regardless of whether STP is enabled or disabled (default) this
command lists the switch’s full STP configuration, including general settings and port settings
Magnum6K25# show stp config
STP CONFIGURATION
-----------------
Spanning Tree Enabled(Global) : NO
Spanning Tree Enabled(Ports) : YES, 9,10,11,12,13,14,15,16
Protocol : Normal STP
