Filter
Top Products
52 78-9000-0192-2 Rev C
Step 8. After writing to the 3M
™
iD Marker is
completed, the following screen will be
displayed. The following messages may
appear in the writing process.
− Message 1. If the overwrite option was
set to "No" And there was data present
on the target market then the following
screen will be displayed;
− Message 2. When writing to a passive
marker or the wrong frequency then the
following will be displayed.
− Message 3. This screen indicates that
X-Type marker option was incorrectly set
to "Yes" or "No". Verify the serial number
that is displayed on the marker ends with
an “X” to select "Yes" for X-Type, else
select "No".
Note: Once the marker data has been locked, the information contained on the marker
is PERMANENT. Choosing to permanently lock the marker data is irreversible. Once
the data is locked it can not be overwritten. Assure that the data that is being written is
correct before proceeding.
A. Modifying Marker Data to be Written
To alter the information to be written into the marker
Press Menu/OK [5:Toggle to MAIN MENU] + Write Mode [SK:1].
Step 1. Select a template from the list on the display
to be written into the marker by pressing
the up/down arrows [SK] to highlight the
preferred template. ‘Last Written/Read’ is
the most recent data that was written to/read
from a marker by the receiver.