Filter
Top Products
17
Step 9 You will need to modify your config.sys file. Find the entry for COM.SYS
(It should be just after the KEYBOARD.DCP statement and before the
VIOTBL.DCP statement. If it is not, arrange the order of the statements
so that this requirement is satisfied.) If there is no COM.SYS or
VCOM.SYS statement, add these to your config.sys file (see the example
for the proper syntax). Be sure these statements are between the
KEYBOARD.DCP and VIOTBL.DCP entries.
Modify the COM.SYS statement using the values you recorded in Step
4:
DEVICE=C:\OS2\BOOT\COM.SYS (x,yyyy,n)
DEVICE=C:\OS2\MDOS\VCOM.SYS
Where: x is either 1, 2, 3, or 4 (COM4 is recommended)
yyyy is the I/O Port Address ( in Hexadecimal) of the modem
n is the IRQ number of the modem
Example: DEVICE=C:\OS2\BOOT\COM.SYS (4,F400,11)
DEVICE=C:\OS2\MDOS\VCOM.SYS
Step 10 Save the new config.sys file. Check that the installation diskette has been
removed from the floppy disk drive and then reboot the system.
Step 11 You will now be able to use your communications programs at the COM
Port you assigned in Step 9.
Configuring UnixWare
Note: These installation instructions are for UnixWare 2.1. Installation on other
versions of Unix may be different. Please consult your operating system
manual or help text for instructions regarding installation of a serial
modem.
Step 1 After you have installed the modem into your machine, turn on the power
and allow the system to boot normally. Log in to Unix as “Desktop User”.
Step 2 Go to Administrative_Tools-Hardware_Setup. This will require the
root password.
Step 3 In the Hardware_Setup main menu, choose Hardware Device
Configuration and press <enter>.