Filter
Top Products
12
The Automator
Press and hold the button on your old remote con-
trol until the display changes to “RETRY”.
Press and hold the same button on your old remote
control once again.
The Automator’s unique DoubleTap learning technology
ensures compatibility with the widest variety of remote
controls ever!
Once you have taught the button twice, the display
will change to either “GOOD” or “FAILED”.
If the “GOOD” label appears on top of the display,
you were successful. Now, press the next button you
wish to teach. Keep repeating steps 6 through 9 until
you have learned all the buttons you want.
If the “FAILED” label appears on top of the display,
try to teach the same button in Automator once
again by repeating steps 6-8.
Continue to teach any commands from any of your
remote controls by repeating steps 5-9 (to go back
to step five, press MAIN once).
Once you completed teaching all the buttons, return
to normal operation by pressing the MAIN button
twice. Test all your new commands. If any of them
don’t work, try learning again using these notes:
Move to another room. Plasma TVs, sunlight, halogen or
quartz lighting can interfere with the learning process.
Although the old remote control seems to work fine,
change the batteries to fresh alkaline batteries.
Vary the distance between the remote controls
gradually. Try 1/4”, 1”, 2”and so on, up to 4 feet.
Tap the button on the original remote control instead of
pressing and holding it during the learning process.
10
11
8
9
7