Filter
Top Products
29
URC-200
Recalling Pre-Programmed Settings
If you didn’t write down the code numbers you setup
your Automator with, you can recall them via this
simple process:
Enter SETUP mode by pressing and holding both
MAIN and ENT for three seconds.
Note: You have 30 seconds for each step, otherwise the
Automator will time out automatically.
Go to page two of the SETUP menu via the PAGE
UP button.
Press the RECAL button. The display changes to the
recall screens. The screen automatically switches
between four screens, alternately flashing page one
devices and code numbers then those for page two.
Note: Pay attention to the page numbers on the bottom
of the screen. Page 1 code numbers are the ones setup
for the Page1 Devices. Page 2 code numbers are the
ones setup for the Page 2 Devices.
Write down the code numbers as they appear. Page
32 of this manual gives a convenient list for you to
note your settings.
Return to normal operation by pressing the MAIN
button twice.
1
2
3
4
5