Adcom URC-200 Universal Remote User Manual


 
21
URC-200
Press the button you want to set as a Macro
button. The top of the screen will display the label
of the button you selected. At the bottom of the
screen it displays “STEP0”, indicating that no
macro steps have been entered yet.
Navigate to the Device and Page that has a button
you want in your macro using the MAIN, DEVICE
and PAGE buttons. Then press the button with the
command you want. Whenever a button is
pressed, another Macro step is counted and
displayed at the bottom of the screen.
Don’t worry about the number of steps. Each
macro button can store up to 190 steps, so you
are not likely to run out of steps!
Note: You can program delays in between commands
by pressing the PAUSE button. Each press adds half a
second to the delay.
Press the LIGHT button to end your macro. A new
screen displays three choices:
Press the MAIN button twice to return to
normal operation.
4
5
6
7
SAVE
Button
SAVE
UNDO
EXIT
If you are happy with your macro, press the
SAVE button.
The UNDO button lets you erase the last step.
The EXIT button erases all the macro steps.