Filter
Top Products
Programming The Mio R-3
21
Mio Modero R-3 Remote
Send_Commands
When used with ZigBee communications and a NetLinx master, the Mio R-3 supports a small set of
Send_Commands. The table below captures all Send_Commands supported by the Mio R3
Send_Commands
@BRT
Set Brightness level
This command can be used to customize the brightness of the red LEDs that
backlight the power button if the predefined brightnesses in Setup Mode are
not fine enough.
Syntax:
@BRT- <awake brightness level>, <sleep brightness level>
Variables:
• # = a value from 0 - 32.
@BRT- # (Set LED Awake brightness level)
@BRT- #, # (Set LED Awake brightness level, sleep brightness level)
Example:
@BRT-16
Sets the awake brightness level to 50%.
@BRT-32,5
Sets the awake brightness level to 100% and sleep brightness level to
approximately 15%
^CFG
Enable or Disable Debug
Mode
Syntax:
^CFG- <command value>
Variables:
• # = (1 = Debug Mode ON, 0 = Debug Mode OFF).
Example:
^CFG-1
Turn Debug Mode ON
^FML
Sets a line of the display to a
menu line
Syntax:
"'^FML-<variable text address range>,S'"
Variables:
• variable text address range = 1; the address range corresponds to the
dynamic line number.
Example:
SEND_COMMAND Panel,"'^FML-1,S'"
Sets dynamic line 1 to a menu line