Filter
Top Products
Programming The Mio R-3
25
Mio Modero R-3 Remote
Send_Commands (Cont.)
^TXT
Assign a text string to those
buttons with a defined
address range
Sets non-unicode text.
Syntax:
SEND_COMMAND <DEV>,"'^TXT-<vt addr range>,<button states
range>,<new text>'"
Variables:
• variable text address range = 1.
• button states range = 1 - 256 for multi-state buttons
(0 = All states, for General buttons 1 = Off state and 2 = On state).
• new text = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Keypad,"'^TXT-1,1&2,Test Only'"
Sets the On and Off state text for the display.
Note: You must send an ^FML command before sending variable text to an
R3 remote.
^UNI
Set Unicode text
For the ^UNI command, the Unicode text is sent as ASCII-HEX nibbles.
Syntax:
SEND_COMMAND <DEV>,"'^UNI-<vt addr>,<unicode text>'"
Variables:
• variable text address range = 1.
• unicode text = Unicode HEX value.
Example:
SEND_COMMAND Keypad,"'^UNI-1,$00,$41'"
Sets the button's unicode character to 'A'.
Note: To send the variable text 'A' in Unicode to all states of the variable text
button 1, (for which the character code is 0041 Hex), send the following
command:
SEND_COMMAND Keypad,"'^UNI-1,$00,$41'"
Note: Unicode is always represented in a HEX value.
WAKE
Force the keypad to turn
backlight on
Syntax:
SEND_COMMAND <DEV>,"'WAKE'"
Example:
SEND_COMMAND Keypad,"'WAKE'"
Forces the keypad to turn backlight on.
ZIGC
Sets the ZigBee Channel
Syntax:
ZIGC <channel> (Decimal)
Example:
ZIGC 26
ZIGP
Sets the ZigBee PAN ID
Syntax:
ZIGP <panId> (Decimal)
Example:
ZIGP 123A