Filter
Top Products
Step 3:
Enter pairing mode – Press and hold the OK and MENU keys simultaneously for
three seconds until all four mode keys flash red twice and you hear two short
beeps to confirm you are in programming mode.
Step 4:
Enter 9 6 6 – Using the numeric keypad on the remote,
enter 9 6 6. The AT&T mode key will flash red twice,
indicating the remote is ready to receive the Home ID.
Step 5:
Enter a new 4-digit Home ID – Using the numeric keypad,
enter the 4-digit Home ID you want to program (using “0–9”
such as 1234). The AT&T mode key on the Point Anywhere
RF Remote Control will flash red twice and you will hear two
short beeps. At the same time, the blue power LED on the
USB converter will flash for two seconds, then remain solid
blue. This indicates that the Home ID pairing was successful.
NOTE: If the pairing process is interrupted or inactive for
more than 10 seconds, the
AT&T
mode key will give a long
red flash and a long beep. This indicates the Point Anywhere RF Remote Control
has left the pairing mode and returned to normal operation without saving any
changes. You will need to start over again.
Optional advanced functions
Setting up the Power Macro control
This feature will set the master power control to power on/off all selected devices
with a single key press. Power Macro can only be assigned to the AT&T mode
key. By default the POWER key will turn the AT&T U-verse Receiver on/off each
time it is pressed. Once the TV is programmed, the POWER key will turn on both
the receiver and the TV. You can also set up power control options, which can
turn the receiver, TV, DVD, and audio device on/off with a single key press. Power
sequence is determined by the order in which the devices were programmed.
Use the instructions below only if you want to change the sequence in which
these devices are powered on and off.
Step 1:
Press the AT&T mode key.
10
Troubleshooting your remote control
Product specifications and notice
Check that the POWER key lights up when you press any button
on the remote control. If not, check whether the batteries are properly
seated or if they need to be replaced.
If one setup method does not work, try another method and you
may have better results.
When the battery power is low, the POWER key will flash red
five times with each key press. Note: The remote control cannot be
programmed when the battery power is low.
If you’re unable to set up using Auto Search, please see “Program
your remote control using manual setup” on p. 6 of this guide.
Model: AT&T U-verse Point Anywhere RF Remote Control
IR Range: up to 30'*
RF Range: up to 100'*
* The range quoted is calculated based on an unobstructed line-of-sight test
under optimum conditions. Actual range will vary depending on conditions
and can be less than the maximum possible. Your actual range will be
limited by several factors, including, but not limited to, battery strength,
electromagnetic interference, infrared interference, and obstructions.
The AT&T U-verse Point Anywhere RF Remote Control is intended and sold
for use only with AT&T U-verse Receivers. May not be compatible with all
entertainment systems or capable of accepting every programming code
for other devices. Limited one-year replacement-only warranty.
15
Additional remote control self-support tools:
On your TV – Press the blue HELP button on the bottom
of your remote, then select Remote Control Setup,
or go to att.com/uverseremote