Filter
Top Products
2Configuring the hardware in the rack
Installing and Configuring the Avaya S8700 or S8710 Media Server 27
June 2004
2 Configuring the hardware in the rack
Once the control network equipment is installed and connected, you must configure the SNMP Modules
in each UPS (if Avaya supplied), the SNMP Subagent in the Avaya Ethernet switch (if Avaya supplied),
and the two media servers. The first two are to allow that equipment to send alarms (traps) to the media
servers.
Configure the SNMP agents first, then install Avaya Communication Manager on and configure the first
media server and verify its operation before you install Avaya Communication Manager on and configure
the second media server.
This section covers the following tasks:
• Configuring the SNMP modules in the UPS on page 28
• Configuring the SNMP subagent in the Avaya Ethernet switch (if used) on page 31
• Configuring the media server on page 33
• Configuring second media server on page 41