AVerMedia Technologies AVerKey300 Universal Remote User Manual


 
AVerMedia AVerKey300 User’s Manual
26
I have set up the AVerKey300 and checked all the connections as
specified in the manual, but I can only get a picture on the VGA monitor,
not on the TV screen.
AVerKey300 is in the “Ready” mode once power is connected. You
need to switch AVerKey
300 “ON”, either from the remote control or
from its touch button panel to display both VGA and VIDEO.
The picture on my TV is distorted.
1. Before doing any adjustments, reset all the picture attributes to the
factory default setting using the “Reset” button on the remote control.
2. Each VIDEO display device is slightly different from another. Use the
Panning Control of
AVerKey300 to adjust the picture.
3. Use the Brightness and Sharpness picture attributes controls on the
remote control to reduce the distortion.
The picture on my TV is all messed up.
1. When using AVerKey300 with the Macintosh, up to 1600 x 1200 can
be supported.
2. When using
AVerKey300 with IBM PC compatible computers,
screen resolutions up to 1600 x 1200 (horizontal frequency less than
108.4KHz) is supported.
There is no image on both my Macintosh monitor and TV.
When you turn on the Macintosh computer, it will first auto-detect the
type of monitor you have. During auto-detection, there won't be any
display on your Macintosh monitor. To avoid this problem, connect your
Macintosh computer, monitor and all the necessary cables to the
AVerKey
300 first before you power on your Macintosh computer.