Filter
Top Products
49
A/C-7P RO, A/C-7S RO
To change the initialization
string, simply input the new
command values. The entire
old string is automatically
erased.
To delete the initialization
string from the NV memory,
simply put nothing between
the parentheses.
Example: &%Z58,1( ) deletes from
NV memory any hex string that had
been previously defined for the
serial port initialization string.
COMMAND 61: AUTOMATIC
PRINT ORIENTATION (APO)
HP PCL only. Laser printers have
the ability to automatically control
page orientation if the user decides
to activate Auto Print Orientation
(APO). Refer to the APO flowchart
(Figure 5-1) in Section 5.3.
VALUE DESCRIPTION
0 APO is NOT
ACTIVE. Print
orientation is
controlled by the
orientation
selections specified
in Commands 62,
63, and 64.
*1 APO is ACTIVE.
The page
dimensions of a
document are
checked to
determine if the
data should be
printed in
landscape because
the width is greater
than the length.
NOTE
APO active is the
recommended selection. A
user can manipulate the
page dimensions using SCS
commands to control the
orientation of the printing as
long as the page size
required is 8 1/2 x 11" or
smaller.
Example: &%Z61,1 enables APO
COMMAND 62: PRIMARY PAPER
TRAY ORIENTATION
HP PCL only. The SCS (LU1) PPM
command specifying the source for
the paper can have a printing
orientation assigned to the paper
tray that is assigned. Refer to the
APO flowchart (Figure 5-1)in
Section 5.7. This command
duplicates the IBM 3812 and 4028
printer’s feature with the additional
selection of option 3 below.
VALUE DESCRIPTION
*0 Computer Output
Reduction (COR)
Mode is active
when paper is
specified to be
selected from the
primary tray
1 Prints PORTRAIT
orientation using
the active font
when the primary
tray is specified
2 Prints
LANDSCAPE
orientation using
the active font
when the primary
tray is specified