Filter
Top Products
When you add an item to a map folder in the Logical Tree, it is
also displayed on the upper left corner of the map. When you
add an item to a map, it is also added under the corresponding
map node in the Logical Tree of the Operator Client.
To configure the Logical Tree you perform some of or all the
following steps several times.
To configure the Logical Tree:
1.
Click to add folders according to your needs.
2. Drag devices from the Device Tree to the appropriate
folders.
You can select multiple devices by pressing the CTRL- or
the SHIFT-key.
3.
Click
to add resource files to your structure.
4.
Select a folder and click to add maps under the
selected folder.
5.
Right-click a folder and click Assign Map to assign a map to
the selected folder.
6.
Select a folder and click to add a Client Command
Script under the selected folder.
7.
Select a folder and click to add a document under
the selected folder.
8.
Select a folder and click to add a camera sequence
under the selected folder.
9. Drag devices from the Logical Tree or the Device Tree to a
map to locate them.
You can add an item only once in a map but you can add it
to several locations in the Logical Tree and to several maps.
Bosch Video
Management System
Basic configuration tasks | en
57
Bosch Sicherheitssysteme GmbH Quick Start Manual 2012.07 | V1 | F.01U.269.054