Filter
Top Products
10
Making connections
* Howling could be produced depending on the location of microphones relative to amp.
This can be remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
* If the amp and microphone are close together, the sound played back from the amp may be
picked up by the microphone. If you record or overdub in such a state, the amp playback
picked up by the microphone will also be recorded. You should separate the amp and
microphone so that the playback from the amp is not picked up by the microphone.
Turning the power on/off
Once the connections have been completed, turn on power to your various devices
in the order specified. By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
When turning the power on: Turn on the power of the amp or mixer
last
.
When turning the power off: Turn off the power of the amp or mixer
first
.
* Always make sure to have the volume level turned down before switching on power. Even
with the volume all the way down, you may still hear some sound when the power is
switched on, but this is normal, and does not indicate a malfunction.
* If you are using batteries, the indicator will become darker when the batteries run down.
Please replace the batteries as soon as possible.
When turning on the power while a recorded track is being selected
(the LOOP PHRASE or ONE SHOT PHRASE indicator is lit), the indicators on the
front panel flash in a sequential order, and the LOOP PHRASE or ONE SHOT
PHRASE indicator flashes rapidly for a few seconds.
RC-20XL_e.book 10 ページ ２００４年４月２８日 水曜日 午後４時１２分