Filter
Top Products
8
Installing batteries
Insert the included batteries as shown in the diagram, being careful to observe the
correct polarity.
fig.03-01
• Batteries are supplied with the unit. The life of these batteries may be limited,
however, since their primary purpose was to enable testing.
• When turning the unit upside-down, get a bunch of newspapers or magazines,
and place them under the four corners or at both ends to prevent damage to the
buttons and controls. Also, you should try to orient the unit so no buttons or
controls get damaged.
• When turning the unit upside-down, handle with care to avoid dropping it, or
allowing it to fall or tip over.
• Be sure to observe the correct + (positive) and – (negative) orientation of the batteries.
• When the batteries run down, the POWER indicator will become dim. When this
occurs, please replace them with new batteries as soon as possible.
If the power is turned off while you are recording or overdubbing, all of the
saved data may be lost (p. 11).
• When replacing the batteries, use six R6/LR6 (AA) batteries.
• Do not mix new batteries with previously used batteries or batteries of a different
type. Doing so may cause battery leakage.
• The running time may be shorter depending on the type of batteries you use.
Expected battery life under continuous use:
Carbon: 6 hours
Alkaline: 16 hours
These figures will vary depending on the actual conditions of use.