Bulldog Security RS114 Universal Remote User Manual


 
SYSTEM FEATURES
SYSTEM COMPONENTS
TECHNICAL ASSISTANCE
1
REQUIRED TOOLS
Four-Button Extended Range Remotely start your car to run the heater, air conditioning or defroster from an extended
Remote Control distance.
Keyless Entry Remotely locks and unlocks your power door locks.
Trunk Release/Sliding Door Remotely open your power trunk or your power sliding van door with a push of a button.
Remote Programmable Run Time Remotely program your vehicle to run 5 to 15 minutes.
Run Time Confirmation Remotely check the programmed run time of 5, 10 or 15 minutes.
Tach/Tachless Option A programmable feature that lets you choose from the easy to install tachless operation or
the wire-in, tach operation.
Parking Light Confirmation Confirms that your vehicle has received a remote signal and will remain on if the engine is
remotely started.
Dome Light Supervision Never walk up to a dark vehicle again. When unlocking the doors by remote control, the dome
light will come on and stay on for 1 minute. This feature will shut off when you activate the
ignition switch or step on the brake.
Cold Start Remotely program your car to start at a preset temperature. Automatically starts your car in
freezing temperature so you never have a dead battery.
Pit Stop Mode Allows you to exit the vehicle while the engine remains running without leaving the key in
the ignition switch.
Extended Range Allows you to operate your system from up to 400 feet away. (800 feet for E Models)
Code Learning Allows your remote starter to learn new remotes, should you want to add remotes, or if remotes
are lost.
Limited Lifetime Warranty Guarantees life-long protection.
Your system includes:
1- Four Button Remote Transmitter
1- Main Control Module
1- 16-Pin Wire Harness
1- 5-Pin Door Lock Harness
6- Heavy Gauge Wires w/ Spade Connectors
1- Hood Pin Switch
1- Extended Range Antenna (E Models Only)
2- Window Antenna Clips (E Models Only)
1- Warranty
1- Warning Sticker for Under the Hood
2-Bulldog Window Decals
1- Installation & Operation Guide
1- Bonus Installation Kit (with selected models)
Should you need help. First check our website at www.bulldogsecurity.com for the most common installation
problems or then our toll-free Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM
EST at 800-878-8007.
Before you begin, check our website at www.bulldogsecurity.com for complete wiring information for your
vehicle.
You must give the following information:
Name
Telephone Number with Area Code (Fax number if applicable)
Year, Make, and Model of the vehicle
The model of the system you are installing
The type of assistance you are requesting
If you give the above information you will be called in the order your call was received.
You may need a 5/16 inch drill bit when mounting the hood pin switch. In most cases no additional tools
are required, however if the bottom of your dash on the driver’s side will come off you must remove it.
In this case a screwdriver or wrench may be needed.