Filter
Top Products
2
®
3
Figure #5
ALMOND
BEZEL
RUBBER KEY
PAD
Figure #2
ALMOND
BEZEL
Figure #4
BEZEL
TABS
ALMOND
BEZEL
Prepare for W-85 Wall Control installation -
Continued
Step 16d. Before attaching the bezel back on to the
front of the switch, make sure that the rubber key
pad is attached to the locating pins on the bezel as
shown in Figure #4.
Step 16e. To attach the bezel back on to the front
of the switch you will need to align the four (4) tabs
on the bezel with the front of the wall control and by
gently pressing on both top and button of the bezel at
the same time, snap the bezel back on to the front of
the switch as shown in both gures #5 and #6.
Step 16f. Check your work by pressing on the light,
fan, reverse and power buttons, making sure that the
buttons do not stick and that each switch functions
properly.
LOCATING
PINS
(4)
BEZEL
TABS
BEZEL
ALIGNMENT
PIN AND HOLE