Filter
Top Products
9
®
3
IN THE WALL BEZEL REPLACEMENT
WALL CONTROL AND HARDWARE (not to scale)
W-85 Wall Control Bezel Replacement installation
as follows - (In the Wall Replacement):
Step 17a. Locate the two (2) screws holding the
switch plate too the wall control and remove the cover
plate as shown in Figure #1.
Step 17a. Locate the four (4) tabs holding the bezel to
the front of the switch, then press in on each tab one at
a time, removing the bezel as shown in Figure #2.
Step 17b. Locate the rubber key pad attached to
the four (4) locating pins as shown in Figure #2 and
remove rubber key pad from the WHITE bezel, also
as shown in Figure #2.
Figure #1
SCREWS
(2)
WARNING!
To avoid possible electrical shock, make cer-
tain that electricity is turned off at the circuit
breaker or fuse box before attempting any in-
stallation or repair procedure
CAUTION! NOT turning the power OFF at the
circuit breaker or fuse box may cause damage to
the electronics within the wall control and or the PC
board on the fan.
Figure #1
BEZEL
BEZEL
TABS
White Wall
Switch Mounting
Screws (2)
Wall Plate Screws
(2) White
(2) Almond
White Wall
Plate(1)
W-85
Wall Control
Switch Bezels
(1) White
(1) Almond
Almond Wall
Plate(1)
(4) Wire Cap