Filter
Top Products
3
®
3
INSTALLING THE W-85 WALL CONTROL
W-85 CONTROL INSTALLATION
1. Use only the Casablanca W-85 wall control.
2. Do not use any additional control with your Inteli-
Touch 3 fan (for example, dimmer, or fan speed
control).
3. Do not use more than one fan per wall control.
4. No other light xtures or electrical appliances may
be connected on the circuit controlled by the W-85
wall control.
W-85 is used to describe either white (-11) or almond nish.
If you have multiple Inteli-Touch 3 fans, refer to the section
"Changing Frequency Setting" on page 6.
1. Remove the screws and switch plate from the existing
switch box.
2. Remove the screws holding the switch in the switch
box.
3. Pull the existing switch from the switch box to expose
the wire connections.
4. Remove the two wires from the switch.
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This
controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this
reason the following precautions must be observed:
CAUTION!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
NOTE: The RED wire is not used in this
application, DO NOT remove the crimped cap
from the wire..
BLACK AND WHITE
STRIPED WIRE
W-85
Wall Control
2 BLACK
WIRES
RED WIRE
NOT USED
(FIGURE #2)
(FIGURE #1)
NOTE: W-85 Wall Control should only be installed on Casablanca's Inteli-Touch
®
3 fans with DOWNLIGHTS
ONLY.
5. Connect the BLACK wire from the POWER
SOURCE that you just removed from the
switch to the BLACK/WHITE STRIP wire on
the W-85 wall control. Secure this connection
with a wire nut.
6. Connect the second BLACK wire that you
just removed from the switch to the second
BLACK wire on the located on the back of
the W-85 wall control. Secure this connection
with a wire nut.
7. Connect the green ground wire coming from
the back of the W-85 control to the ground
wire in the switch box. Secure the splice with
a wire nut.
8. Check your work by using the wiring
diagrams as shown in Figures # 1 and #2.
9. Install the W-85 in the wall box with the two
long screws provided.
10. Install the wall plate with the two color-
matched screws.
SINGLE W-85 INSTALLATION
W-85