Filter
Top Products
4
®
3
To control the fan and lights from two
locations (a three-way circuit), use two
W-85 wall controls.
1. Remove the screws and switch plate from the existing switch
box and the screws holding the switch in the switch box.
2. Pull the existing switch from the switch box to expose the wire
connections.
3. Determine which wire is connected to the common terminal
from the power source (120V AC) of the three-way switch.
(The terminal will be marked on switch).
CAUTION!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
DUAL W-85 INSTALLATION
To control the fan and lights from two locations (a three-way circuit), use two
W-85 wall controls as shown in the wiring diagram in Figure #1. Before
installing the two switches into the wall, place both switches side by
side, then locate the 4 dip switches on the side of the two switches as
shown in Figure #2. Then make sure that the dip switches are set to the
same address on both switches as shown in Figure #2. When setting
these dip switches you are setting the channel number that is required
to control both your fan and lights from both sides of the room. If you are
installing other Inteli-Touch 3 fans within your home you may need to
reset the dip switches on these other fans to a different channel before
installing your W-85 wall control into the wall. Please review the section
on channel changing within this part of the operation manual as shown
on page #6.
W-84
BLACK
BLACK
BLACK
BLACK
BLACK
BLACK
BLACK
RED
GREEN
120V AC
BLACK
BLACK WITH
WHITE STRIPE
W-84
RED
RED
RED
BLACK WITH
WHITE STRIPE
GREEN
NEUTRAL
WHITE
GREEN
(FIGURE #1)
(FIGURE #2)
DIP SWITCHES
W-85
Wall Control
BLACK AND WHITE
STRIPED WIRE
2 RED WIRES
2 BLACK
WIRES
(FIGURE #3)
4. Remove the wire from the common terminal of the three-way switch.
Connect this wire to the remaining black/white striped wire on the
W-85 control. Secure this splice with a wire nut.
5. Remove the two remaining wires from the three-way switch.
Connect the black wire of these wires to a black wire on the
W-85 control. Secure the splice with a wire nut. The remaining
red wire is to be connected to the other red wire on the
W-85. Secure the splice with a wire nut.
6. Connect the green ground wire coming from the back of the W-85
control to the ground wire in the switch box. Secure the splice with
a wire nut.
7. Check your work by using the wiring diagrams as shown in Figures
# 1 and #3 on this page.
8. Install the W-85 in the wall box with the two long screws provided.
9.Install the wall plate with the two short color-matched screws
provided.
10.Installation of the second W-85 control is identical. Repeat steps
1 through 7.
W-85
W-85