Filter
Top Products
14
been triggered, signal becomes “Low”, and it will stop all alarm activities. Under
normal operation, signal remains “High”.
PIN 14. ALARM INPUT
To connect wire from ALARM INPUT ( PIN 14 ) to GND ( PIN 9 ) connector, DVR
will start recording and buzzer will be on. When alarm has been triggered, signal
becomes “Low”, and it will stop all alarm activities. Under normal operation, signal
remains “High”.
PIN 15. COM
Under normal operation COM connect with NC and disconnect with NO. But when
alarm triggered, COM disconnect with NC, and connect with NO.
4. Power input
Connect to power cord (standard package attached).
3.4 Menu setup
To press ”MENU” to enter main menu. You will
need to enter password to access main menu.
To press “◄” “►” to move digit, and to press ”
▲” “▼” to select number. To press ”ENTER”
button to confirm password.
Ex.: Password : 0000 (Default : 0000)
Password : 0000
After keying in correct password, and confirm
by pressing ”ENTER” button, screen will show
following options.
Timer ------- Scheduling Record
Record ------- Record Mode Setup
Alarm ------- Alarm Mode Setup
Remote ------- Remote Control Setup
System ------- System Setup
Event -------- Event List
(Menu)
► Timer
Record
Alarm
Remote
System
Event
3.5 System setup