Filter
Top Products
18 Series LCD TV
PAGE 17
In Clear All mode, press【OK】/【V+】to unlock all of the programs.
Note: In child lock menu operation, each function cannot be activated until the correct
password is entered. If the password is forgotten, the default password of “1601” is still valid.
Using the PC Setting menu (for PC mode only)
1) Press【MENU】and then use【V+】/【V-】 to select the PC Setting menu.
2) Press【P+】/【P-】to select the desired field.
● Auto Tracking
To adjust automatically the picture’s clock、phase 、H Position and V Position to get the
best visual effect
.
● Phase
To adjust pictures’ sampling phase in PC mode
● Clock
To adjust pictures’ sampling frequency .
● H Position
To adjust picture’s position horizontally in PC mode.
● V Position
To
adjust picture’s position vertically in PC mode.
Note:
In the menu, gray items means invalid to operate in the
current mode.
Standby Mode
Press the 【
】 on the TV panel/Remote Control, the LCD TV will store the current setup
and enter into the standby mode with a red indicator light. To Power on the LCD TV, press
the button again.
Signal Switch
Press【TV/AV】on the remote control to select the signal sources orderly. They are TV, AV1,
AV2, YPbPr, PC, and DVI.
The upper-right corner of the screen will display the corresponding information.
Channel Selection
Press【CH+】/【CH-】on the panel or【P+】/【P-】on the remote control to increase/decrease
the channel number. If a channel number is in SKIP ON mode, the next channel will display
orderly.
Three numbers can be input at most, if you use the number button on the remote control.
OTHER FUNCTIONS INTRODUCTION