Filter
Top Products
Installation Instructions LVS1U / LVSXU
11
INSTALLING INTERFACE BRACKETS
1. Place displays face down on a soft, non-abrasive surface.
CAUTION: Using screws of improper diameter may
damage your display! Proper screws will easily thread into
display mounting holes.
2. Select screw diameter by examining hardware (A-C and F-H)
(6mm or 8mm) and comparing with mounting holes on
display. (See Figure 10)
3. Select spacers:
• Spacers are NOT
required if mounting holes are not
recessed and interface brackets (X) can lay flat against
display.
• Spacers (E) ARE
required if mounting holes are
recessed, or if protrusions prevent interface brackets
(X) from laying flat.
CAUTION: Using screws of improper length may damage
your display! Proper screws will have adequate thread
engagement without contacting bottom of display mounting
holes.
4. Select screw length: (See Figure 10)
• By hand, insert SHORTEST length screw of selected
diameter (A or F) through 3/16" washer (D, if using
screw A), bracket (X), selected spacer (E, if required),
into display mounting hole. Do NOT thread screw into
hole at this time.
• Proper screw length requires base of screw head to
protrude above flat washer (if flat washer is used) a
distance equal to or greater than the screw diameter. If
screw length is inadequate, select longer screw. Select
shortest screw which will protrude the required
distance.
Figure 10
5. Make sure diamond on interface brackets is even with
center of display. (See Figure 10)
6. Use selected screws (A-C or F-H), washers (D, if using
screws A, B or C) and spacers (E), if necessary, to connect
interface brackets (X) to back of display. (See Figure 10)
ADDING DISPLAYS TO MOUNTS
1. Raise display with attached interface brackets and hook top
of brackets into top of mount. (See Figure 11)
2. Slowly bring bottom of display in towards mount until it clicks
into place.
3. Repeat Steps 1 and 2 for remaining mounts in that row.
Figure 11
4. The displays can be easily removed by pulling both
interface bracket cords down. (See Figure 11)
5. Pull the bottom of the display out.
6. Lift up display to lift hooks off the mount.
6
(A-C or F-H) x 4
(D) x 4
(E) x 4, if
required
(X)
5
Match diamond
with center of
display
Bracket kickstand
may be raised to
allow hardware
attachment
Interface
bracket
hooked over
mount
(Display not shown)
(LVS1U shown
as example)
1
1
4
4
5