Filter
Top Products
Installation Instructions Model MSP-DCCMD
3
CONTENTS
TOOLS REQUIRED FOR INSTALLATION
• Electric drill and bit set
• Hex wrench set
• Phillips screwdriver
• Level
NOTE: Other tools may be required depending on the
mounting surface and method of installation.
Inspect The Unit Before Installing
WARNING: Watch for pinch points. Do not put your
fingers between movable parts.
1. Carefully inspect the mount for shipping damage. If
any damage is apparent, call your carrier claims
agent and do not continue with the installation until
the carrier has reviewed the damage.
NOTE: Read all instructions before starting installation.
2. Lay out components to ensure you have all the
required parts before proceeding
(see JWD drawing on page 4).
SPECIFICATIONS
Table 1 below provides the JWD specifications.
INTRODUCTION
The installation process involves three key steps, as
follows:
• Select mounting configuration
• 100mm x 100mm Centris mounting (flush
and recessed)
• 200mm x 100mm Centris mounting with
interface adapter
• the interface adapter that accommodates two
mounting hole patterns: 400mm x 200mm
and 550 x 235mm
• Connect cables
• Make adjustments
IMPORTANT WARNINGS AND CAUTIONS! .......... 2
DIMENSIONS .......................................................... 2
TOOLS REQUIRED FOR INSTALLATION ............. 3
Inspect The Unit Before Installing ............................ 3
SPECIFICATIONS ................................................... 3
INTRODUCTION ..................................................... 3
PARTS (Continued) ................................................. 5
WALL BRACKET INSTALLATION .......................... 6
Secure Wall Bracket ......................................6
Attach Mount to Wall Bracket .........................6
INSTALLATION (100mm x 100mm) ..............7
Flush Mount Centris Bracket to Display ............7
Recess Mount Centris Bracket to Display ........7
INSTALLATION (200mm x 100MM)......................... 8
Attach Interface Adapter to Display ...............8
Attach Display to Centris Bracket ..................8
INSTALLATION
(400mm x 200MM and 550mm x 235MM) ............... 9
Attach 400mm x 200mm Interface Adapter ...9
Attach 550mm x 235mm Interface Adapter ...9
Attach Display to Centris Bracket ..................9
CABLE MANAGEMENT .......................................... 10
ADJUSTMENTS ...................................................... 10
LATERAL TENSION ADJUSTMENT .............10
PITCH ADJUSTMENT ...................................10
Table 1: JWD Speifications
Depth from
Wall
2-11/16” (68mm)
Maximum
Extension
20-3/8” (51.8cm)
Dimensions W
x H x D
13-1/8” x 14-11/16” x 2-11/16”
(308 x 373 x 68mm)
Weight
Capacity
75 lbs (34kg)