Filter
Top Products
Installation Instructions Model MSP-DCCMD
9
INSTALLATION (400mm x 200MM and
550mm x 235MM)
Attach 400mm x 200mm Interface Adapter
NOTE: Used for 400mm x 200mm hole patterns.
1. Select six M6 screws (30) and six spacers (120) from
parts bag.
2. Place display face down on a clean dry surface.
3. Install six M6 screws (30) into the six mounting holes
on the interface bracket (130). (see figure 8)
4. Slide six retaining spacers (120) onto six M6 screws
(90).
NOTE: The arrow on the interface bracket (130) must
point toward the top of the display.
5. Align interface bracket (130), with screws (30) and
spacers (120), with mounting holes in display back.
6. Tighten all screws.
Attach 550mm x 235mm Interface Adapter
NOTE: Used for 550mm x 235mm hole patterns.
1. Select four M6 screws (30) and four spacers (120)
from parts bag.
2. Place display face down on a clean dry surface.
3. Install four M6 screws (30) into the four mounting
holes on the interface bracket (130). (see figure 9)
4. Slide 4 retaining spacers (120) onto four M6 screws
(30).
NOTE: The arrow on the interface bracket (80) must
point toward the top of the display.
5. Align interface bracket (130), with screws (30) and
spacers (120), with mounting holes in display back.
6. Tighten all screws.
Attach Display to Centris Bracket
1. Start two M4 x 5mm Phillips pan head screws (70) into
the top two mounting holes of the previously attached
interface bracket. (see figure 10)
2. Hang the mount from the two screws started in Step 1.
3. Install the remaining two M4 x 5mm Phillips pan head
screws (70) into the bottom mounting holes of the
display.
4. Secure the display to the mount (Centris bracket) by
tightening all four M4 x 5mm Phillips pan head screws
(70). (see figure 10)
Figure 8: Attach 400mm x 200mm Interface Adapter
Figure 9: Attach 550mm x 235mm Interface Adapter
Figure 10: Attach Display to Centris Bracket
30
Arrow must
point to top of
display
130
120
Display
130
120
30
Arrow must
point to top of
display
Display
Centris Bracket
70
70