Filter
Top Products
Model MSP-DCCMD Installation Instructions
6
WALL BRACKET INSTALLATION
Secure Wall Bracket
WARNING: It is the responsibility of the installer to
verify that the surface to which the mount is anchored
will safely support the combined load of all attached
components and equipment.
To install the mount:
1. Determine the exact mounting location prior to
installation, considering the unit’s swing and
extension radius.
2. Using the wall bracket (150) as a template, mark the
two pilot holes for mounting the wall bracket.
(see figure 2)
3. Drill two 1/4” pilot holes a minimum depth of 2” into the
wood stud.
NOTE: Make sure the wall bracket is level before
installing the lag bolts.
4. Using a 9/16” socket wrench, install two lag bolts (20)
to secure the wall bracket (150) to the wall. Do not
overtighten the lag bolts.
IMPORTANT ! : Overtightening lag bolts may cause
bracket to compress into soft wall surface, resulting in
difficult mount installation or improper engaging of set
screw in step 2 below. If this occurs, remove bracket,
install 3/8" steel washers as required between bracket
and wall surface, and reinstall bracket.
NOTE:
• For a flush mount application, perform the “Attach
Mount to Wall Bracket” on page 6 and then
perform the “Flush Mount Centris Bracket to
Display” on page 7.
• For a recessed mounting application, omit the
procedure to “Attach Mount to Wall Bracket” on
page 6 and proceed to the “Recess Mount Centris
Bracket to Display” on page 7.
Attach Mount to Wall Bracket
1. Align the top of the mount (10) with the top of the wall
bracket (150). Push the bottom of the mount against
the bottom of the wall bracket until the mount fits
snugly in place (see Figure 3).
2. Using the 5/32” hex wrench (180), secure the mount
to the wall bracket by tightening the set screw
(see figure 3). Ensure set screw engages back side
of bracket to properly secure mount.
Figure 2: Secure Wall Bracket
Figure 3: Attach Mount to Wall Bracket
Wood
Stud
150
20
1/4" Pilot
Holes
10
150
Set Screw
180