Filter
Top Products
Model MSP-DCCMD Installation Instructions
8
INSTALLATION (200mm x 100MM)
Attach Interface Adapter to Display
1. Select six M4 screws (80) and six spacers (190) from
parts bag.
2. Place display face down on a clean dry surface.
3. Install six M4 screws (80) into the six mounting holes
on the interface bracket (140). (see figure 8)
4. Slide six retaining spacers (190) onto six M4 screws
(80).
NOTE: The arrow on the interface bracket (140) must
point toward the top of the display.
5. Align interface bracket (140), with screws (80) and
spacers (190), with mounting holes in display back.
6. Tighten all screws.
Attach Display to Centris Bracket
1. Start two M4 x 8mm Phillips pan head screws (70) into
the top two mounting holes of the previously attached
interface bracket. (see figure 7)
2. Hang the mount from the two screws started in Step 1.
3. Install the remaining two M4 x 8mm Phillips pan head
screws (70) into the bottom two mounting holes of the
display.
4. Secure the display to the mount (Centris bracket) by
tightening all four M4 x 8mm Phillips pan head screws
(70). (see figure 7)
Figure 6: Attach Interface Breacket to Display
Figure 7: Attach Diaplay to Centris Bracket
140
80
190
Centris Bracket
Display
70