Filter
Top Products
11
-%.5
#$4
%*%#4
/0123
Front Panel
1 Standby button & LED indicator
e front panel Standby button will toggle the transport between its fully
operational status and a standby mode that leaves the transport off , yet
ready to respond to system commands via any of the supported control
options (e.g. IR input, DC trigger, CAN-Bus, or RS-232).
e current state of the transport is indicated by the LED on the Standby
button on the front panel. When the unit is powered and switched on, this
LED indicates the following:
• On = standby
• Flashing (on power-up) = initialization
• Off = operate
• Flashing (after power-up) = AC mains voltage out of range
If you are not going to use the transport for an extended period of
time, e.g. vacation or other travel, we suggest you disconnect it from
the AC mains. Please be certain that the transport is in standby prior to
disconnecting it from the AC mains.
Also, it is a good practice to physically disconnect any and all valuable
electronics from the AC mains during electrical storms, as a lightning
strike anywhere near your home can put a tremendous surge on the AC
mains that will easily jump across a simple power switch. e resulting
surge (which may be many thousands of volts) can damage any piece
of electronics, no matter how well designed and protected. e best
protection in the case of severe electrical storms is simply to remove the
electronics from any connection with the power grid.