Filter
Top Products
8
register your purchase! Having found the serial number, now would be a good time to register your
product on the Classé web site or fi ll out the registration card. Please register
your purchase so we can advise you of updates and other items of interest.
It will take only a minute or so. Please register your product on line or complete
the card now, before you forget.
operating voltage e CDT-300 disc transport is set at the factory (internally) for 100V, 120V,
220V, 230V, or 240V AC mains operation, as appropriate for the country in
which it is to be sold. (230V only in European Union countries, in compliance
with CE regulations.) e voltage setting may not be changed by the user.
Make sure that the label on the rear panel of your DVD transport indicates
the correct AC operating voltage for your location. Attempting to operate your
DVD transport at an incorrect voltage may damage the unit.
Warning: The voltage setting of your DVD transport may not be
changed by the user. There are no user-serviceable
parts within the unit. Please refer any problems to an
authorized Classé service center.
If the AC mains voltage indicated on your DVD transport is incorrect, please
contact your local authorized Classé dealer or distributor.
e CDT-300 includes protection circuitry that will prevent the transport from
operating at dangerously high or low voltages.
• At startup: the AC mains voltage must be within a range of approximately
-15% to +10% of its nominal value at startup, or the transport will not
turn on. For example, a 120V unit requires the AC mains to be between
approximately 95V–135V in order to turn on.
• Overvoltage during operation: if the AC mains voltage surges by roughly
10% or more during operation, the transport will enter protection mode
and shut down. e standby LED (Light-Emitting Diode) will fl ash to
indicate the protection mode has been engaged. An error message will be
displayed on the LCD touchscreen.
• Under-voltage during operation: if the AC mains voltage sags by 15%
or more, the transport will continue to play (since this does not present
a particular danger to the transport), but note that it may not be able
to achieve its usual standard of performance under these compromised
conditions. e Standby LED will fl ash to indicate the condition.