Filter
Top Products
13
COMPOSITE S-VIDEO Pr Pb Y
CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK, GROUNDING
OF THE CENTER PIN OF THIS PLUG MUST BE MAINTAINED
AVIS! POUR RÉDUIRE LE RISQUE DE CHOC ÉLECTRIQUE
LA FICHE CENTRALE DE LA PRISE DOIT ÊTRE
BRANCHÉE POUR MAINTENIR LA MISE À LA TERRE
/.
/&&
100/120~ T500mAL250V
230/240~ T250mAL250V
Rear Panel
1 Analog Video Outputs
e CDT-300 is equipped with a complete set of analog video outputs:
Component (Y, Pb, Pr), S-Video, and Composite. e S-Video output
employs the standard S-Video (mini-DIN) connector, while the
Component and Composite outputs employ high quality RCA connectors.
Note that the three analog video standards off er varying degrees of
performance:
• Component video renders the best analog video quality, and
provides compatibility with progressive and high defi nition
video signals. As a result, the component outputs are the analog
outputs you will want to use in order to take full advantage of
the video scaling and processing capabilities of the CDT-300.
( e HDMI output also supports video scaling and processing.)
• S-Video is capable of rendering a high quality video image, but is
limited to standard defi nition, interlaced signals.
• Composite video is the most common analog video interface,
available on almost all display devices. Like S-video, it is also
limited to standard defi nition, interlaced signals.
For this reason, you are advised to use component video connections
whenever possible.
All three analog video outputs are active simultaneously. Connect the
appropriate video output(s) of the CDT-300 to the corresponding inputs
of your A/V preamplifi er/processor using high quality video cables. Your
Classé dealer can assist you in making an appropriate cable selection.
Note that due to Macrovision copy protection software, all HD resolutions
may not be available depending on the disc.