Curtis Mathes CMC13003 TV VCR Combo User Manual


 
7
C
HAPTER
T
WO
: I
NSTALLATION
I
NSTALLATION
Connecting VHF and UHF
Antennas, continued
If you use a 300-ohm antenna
with twin flat leads, follow the
directions below, but skip step 1.
1 Push the stem of the rod
antenna into the antenna
mount.
2 Connect both antenna leads
to the combiner.
3 Plug the combiner into the
terminal on the rear panel of
the TV/VCR.
Connecting Cable TV
Systems to the TV/VCR
Choose one of the sections below
for connecting a cable system.
This TV/VCR is cable-ready; you
don’t need a converter for basic
cable channels.
Cable Without a
Converter Box
To connect cable without a
converter box:
1 Plug the incoming cable into
the terminal on the rear
panel of the TV/VCR.
Cable With a
Converter Box
If your cable company
scrambles some channels and
requires you to use a converter
box for only those channels, use
these instructions.
You will need the following
pieces of equipment, which you
can purchase from an
electronics store:
A two-way splitter
An RF (A/B) switch
Four lengths of coaxial cable
1 Plug the incoming cable into
the 2-way splitter.
AA68-00951A/eng 10/26/00 8:52 AM Page 7