Filter
Top Products
If your cable wire is connected to your TV without a
converter or descrambler box, unscrew the wire
from your TV and attach it to the RF IN (FROM ANT.)
jack on the rear panel of the HDD/DVD Recorder.
Use the supplied RF cable to connect between the
HDD/DVD Recorder’s OUT (TO TV) jack and the
antenna input jack on your TV. With this connection,
you can receive all midband, superband, and
hyperband channels (all cable channels).
Connecting a TV
Choose one of the following TV connections,
depending on the capabilities of your equipment.
RF Connection
Connect the ANT OUT (TO TV) jack on the HDD/DVD
Recorder to the antenna in jack on your TV using the
supplied 75-ohm RF cable (R).
Scart Connection
1
Plug a scart cable into the scart socket EURO
AV1 at the back of the HDD/DVD Recorder and
the corresponding scart socket at the back of
the TV set. (V)
2
Plug a scart cable into the blue scart socket
EURO AV2/DECODER at the back of the
HDD/DVD Recorder and the corresponding
scart socket at the back of the Decoder.
INTRODUCTION
15
Connections
Connections
Connecting Antenna/Cable
1
Disconnect the antenna/cable from the rear of
your TV.
2
Connect this cable to the jack marked ANT IN
(FROM ANT.) on the rear panel of the HDD/DVD
Recorder.
• There are a variety of ways to connect the
HDD/DVD Recorder to your TV and other
equipment. Use only one of the connections
described below. Whichever TV connection
you use will work with all input sources.
• Please refer to the manuals for your TV, VCR,
stereo system, or other devices as necessary to
make the best connections.
• For better sound reproduction, connect the
HDD/DVD Recorder’s AUDIO OUT jacks to the
audio in jacks of your amplifier, receiver,
stereo, or audio/video equipment. See
‘Connecting an Amplifier/Receiver‘ on page 16.
Caution
• Make sure the HDD/DVD Recorder is
connected directly to the TV, and the TV is set
to the correct video input.
• Do not connect the HDD/DVD Recorder’s
AUDIO OUT jack to the phone in jack (record
deck) of your audio system.
• Do not connect the HDD/DVD Recorder via
your VCR. The DVD image could be distorted
by the copy protection system.
Antenna
Antenna
Cable TV
Wall Jack
Flat Wire
(300ohm)
300/75ohm Adapter
(Not supplied)
OR OR
Rear of HDD/DVD Recorder
CONNECTIONS
ANTENNA
INPUT
Y
Pb
Pr
COMPONENT/PROGRESSIVE VIDEO INPUT
S-VIDEO
INPUT
RV
S C
Rear of HDD/DVD Recorder
Rear of TV
This set doesn’t have a modulator output. However
it still applies the RF through Output.
DG-M32D1P-2A(GB) 2006.5.16 4:39 PM ˘ ` 15 mac001 1200DPI 100LPI