Filter
Top Products
60
Troubleshooting
Symptom Cause Solution
When the HDD/DVD Recorder is moved from a cold
place to a warm place.
Under extremely humid conditions.
Keep the HDD/DVD Recorder plugged into an AC
power outlet with the power on. This will help
prevent condensation.
When condensation has occurred, wait a few hours
for the HDD/DVD Recorder to dry before using it.
Moisture Condensation
Moisture condensation can occur: In locations where moisture condensation may occur:
RESET :
If the set is in malfunctions, press [DVD/HDD] key on the front panel for 5 seconds or unplug the power cord,
and then plug it in after 5 seconds. As this set is a Digital Multimedia Product, malfunction may occur.
Use another disc.
You cannot record the source.
Select the channel on the HDD/DVD
Recorder’s built-in TV tuner.
Set clock to correct time. See ‘Set Clock‘
on page 21.
Reprogram Timer. See ‘Timer Recording‘
on page 42~44.
Reprogram Timer.
No solution.
No solution.
Make A/V connections. Stereo is available
only via A/V output from HDD/DVD
Recorder.
Select AUX or A/V source as TV input.
Set TV audio channel mode to Stereo.
See ‘Changing the TV Audio Channel‘ on
page 33.
Point the remote control at the remote
sensor of the HDD/DVD Recorder.
Operate the remote control within 23 ft
(7m).
Remove the obstacle.
Replace the batteries.
The remaining blank space on the
disc is insufficient.
The source you are trying to record is
copy-protected.
When setting the recording channel,
the channel is tuned on your TV’s
tuner.
Clock in HDD/DVD Recorder is not set
to correct time.
Timer has been programmed
incorrectly.
TIMER indicator light does not appear
after programming timer.
TV is not Stereo-compatible.
Broadcast program is not in stereo
format.
HDD/DVD Recorder A/V Out jacks are
not connected to TV A/V In jacks.
HDD/DVD Recorder Audio/Video Out is
not selected for viewing at the TV.
HDD/DVD Recorder’s TV audio
channel is set to BIL or MONO.
The remote control is not pointed at
the remote sensor of the HDD/DVD
Recorder.
The remote control is too far from the
HDD/DVD Recorder.
There is an obstacle in the path of the
remote control and the HDD/DVD
Recorder.
The batteries in the remote control are
dead.
Cannot record or did not
record successfully.
Timer Recording not
possible.
Stereo Audio Record
and/or Playback not
present.
Remote control does not
work properly.
DG-M32D1P-2A(GB) 2006.5.16 4:40 PM ˘ ` 60 mac001 1200DPI 100LPI