Filter
Top Products
74
ENGLISH
Symptom PageCheck
An image is not projected with an
HDMI/DVI connection.
16, 17
16, 17
49
16, 17
43, 44
• Check the HDMI/DVI connection.(Check the status of the HDMI/DVI-related indicators.)
• Check whether the connected monitor equipment or other equipment supports HDCP.
(The DVD-2910/955 will not output a video signal unless the other equipment supports
HDCP.)
• Check the settings of “HDMI/DVI SELECT”.
• Check whether the output format of the DVD-2910/955 (HDMI/DVI FORMAT) matches
the supported input format of other connected equipment.
• Check whether the video output setting at “PURE DIRECT” is set to “VIDEO: OFF” or
“ALL OFF”.
Remote control unit does not operate.
20
20
20
20
20
• Check that the batteries are inserted in the proper “<” and “>” directions.
• The batteries are dead. Replace them with new batteries.
• Point the remote control unit at the remote control sensor when operating it.
• Operate the remote control unit within a distance of 7 meters from the remote control
sensor.
• Remove the obstacle between the remote control unit and remote control sensor.