Filter
Top Products
19
CHAPTER 4 BASIC OPERATION
BASIC OPERATION
CHAPTER 4
This chapter is intended to help you get your DVR up and running before you activate any
advanced features which are covered in later chapters. You can use the mouse, remote
control and the buttons on the front of the DVR to operate your system, but for convenience,
we will be discussing operations using the mouse.
4.1 POWER ON/OFF
Connect the power cable to the DC 12V port on the rear panel. At startup, the system
performs a basic system check and runs an initial loading sequence. After a few moments,
the system loads a live display view.
STANDBY MODE
The system can be put into Standby Mode. Power will remain to the system but will not be
recording.
To Start/Stop Standby Mode:
Press and hold the POWER button on the front panel or remote control until the prompt
closes. The system enters standby mode.
Press and hold the POWER button on the front panel or remote control until the system
beeps. The system will begin powering up.
Select “Standby” in the pop-up Shortcut menu (described in the next section)
SHUTDOWN
When the DVR will not be in use for an extended period of time, it is recommended that you
shut it down completely. To do so, follow the above instructions to put the DVR into Standby
mode. Once the DVR has gone into hibernation disconnect it from its power source. Turning
off the surge protector that it is plugged into is the preferred method.
4.2 SHORTCUT MENU
The Shortcut menu gives direct access to many of the system’s functions, features and
options without having to go through a series of intermediiate steps.
Right-clicking with the mouse anywhere on the screen will bring up the Shortcut menu.
PICTURE 4-1
M A I N M E N U
M U L T I P I C T U R E
P T Z
V I D E O S E A R C H
M U T E
S T A RT R E CO R D
S T O P R E C O R D
S T A RT C R U I S E
S T A N D B Y
V I D E O S E QU E N C E
MAIN MENU: Opens the main system menu
MULTIPICTURE: Choose multi-screen mode
PTZ: Opens the PTZ control menu
VIDEO SEARCH: Open the Search Menu to view
recorded video
MUTE: Mute listen-in audio on the system
START RECORD: Start manual recording
STOP RECORD: Stop manual recording
START CRUISE: Activates preset PTZ cruise
STANDBY: Click to go into standby mode
ROTATION: Start full screen cycle through
channels
To close the Shortcut menu, click anywhere on screen.