Filter
Top Products
43
CHAPTER 6 ADVANCED FEATURES
6.5 PAN-TILT-ZOOM CAMERAS (PTZ)
Use the PTZ Setup menu to configure settings for an optional PTZ camera.
PICTURE 6-8
NOTE! Consult the instruction manual of your PTZ camera for complete
information about your camera, including protocol and baud rate.
Configuring a PTZ camera:
STEP 1. Connect a PTZ camera to the BNC and 485A (TX, +) and 485B (RX, -) ports and
power outlet.
STEP 2. PROTOCOL Select PELCO-D or PELCO-P for the selected channel.
STEP 3. BAUD RATE Select 1200, 2400, 4800, or 9600.
STEP 4. DATA BIT Select 5, 6, 7, or 8.
STEP 5. STOP BIT Select 1 or 2.
STEP 6. VERIFY Select ODD, EVEN, MARK, SPACE, or NONE.
STEP 7. ADDRESS Enter an address from 001~255 using the Virtual Keyboard. Refer to
your PTZ camera`s instruction manual for further details.
STEP 8. Click APPLY and then click CLOSE in the confirmation window.
STEP 9. Click EXIT in all menus until all windows are closed.
The menu will only display four channels at a time. The pull-down menu in the upper left of the
menu allows you to switch between groups of four channels; 1-4, 5-8, 9-12 and 13-16.
The PTZ setting options for each camera can be selected independently and are available
below each camera’s channel number.