Filter
Top Products
19
© 2001 Directed Electronics, Inc.
■
Before installing the unit, connect the
wiring temporarily and test the system for
proper operation.
■
Use only the parts included with the unit
to ensure proper installation. The use of
unauthorized parts can cause malfunc-
tions. Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
■
Install the unit where it does not get in
the driver's way and cannot injure the pas-
senger if there is a sudden or emergency
stop. For optimum performance, this unit
should NOT be mounted at an angle of
more than 30 degrees from horizontal.
■
Avoid installing the unit where it would be
subject to high temperature, such as direct
sunlight, hot air from the heater, or where
it would be subject to dust, dirt, or
excessive vibration.
NOTE: Do not mount the unit where it will be stepped on
or where items will be placed on top of or spilled
into the unit.
DIN FRONT/REAR-MOUNT
This unit can be properly installed either from
"Front" (conventional DIN Front-mount) or
"Rear" (DIN rear-mount installation, utilizing
threaded screw holes at the sides of the unit
chassis). For details, refer to the following illus-
trated installation methods.
DIN FRONT-MOUNT (METHOD A)
INSTALLING THE UNIT
1. Dashboard
2. Half Sleeve - After inserting the half sleeve
into the dashboard, select the appropriate
tab according to the thickness of the dash-
board material then bend them inward to
secure the half sleeve in place.
3. Screw
1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5x25mm)
6. Screw
6. Strap - Be sure to use the strap to
secure the back of the unit in place.
Bend the strap by hand to achieve
the desired angle.
7. Plain washer
1
2
4
3
7
5
6
Fig.2
182
93
1
2
3
Fig.1
30
Installation