Filter
Top Products
20
© 2001 Directed Electronics, Inc.
REMOVING THE UNIT
1. Trim ring.
2. Remove the trim ring by first detaching
the face plate. Then using your fingers,
press up and down at the top and bottom
of the trim ring and pull out.
3. Insert the removal keys into the slots at
either side of the unit until they click.
Gently pull the unit sliding it out of the
mount.
DIN REAR-MOUNT (METHOD B)
Install using the screw holes on the sides of the
unit.
To fasten the unit to the factory radio mounting
bracket:
1. Select a position where the screw holes of
the bracket and the screw holes of the
main unit become aligned (are fitted) and
tighten the screws at two places on each
side. Use either truss screws (5x6mm) or
flush surface screws (4x6mm) depending
on the shape of the screw holes in the
bracket.
2. Screw
3. Factory radio mounting bracket
4. Dashboard or console
5. Hook (Remove this part)
NOTE: The trim ring and half-sleeve are not used for
method B installation.
1
2
4
5
5
3
2
1
3
2