DirecTV HUGHES/ HTL-HD Satellite TV System User Manual


 
26
3-4. Connecting to Antennas - Oval Dish (Satellite A, B, C)
Receiving Signals
1.
Connect the “Antenna” to the “ANT IN” jack on the DIRECTV
®
HD Receiver using a coaxial RF cable.
2.
Connect the cable TV signal to the “CABLE IN” jack on the DIRECTV HD Receiver using a coaxial RF cable.
3.
Connect “Output” of the multi-switch to the “SATELLITE IN” jack on the DIRECTV HD Receiver using a
coaxial RF cable. (For proper dish installation, refer to the “Installer’s Guide” provided with your satellite dish
antenna).
4.
Connect the “Phone Wall Jack” to “PHONE JACK” on the DIRECTV HD Receiver using a phone cable.
* Sat C may also be connected via a SAT B/SAT C combiner with a 4x4 multi-switch (not supplied by HUGHES).
(1080i/720p/480p)(1080i/720p/480p)
RGB OUT
DATA PORT
DVI-HDTV OUT
SATELLITE
IN
TYPE
CABLE IN
ANT IN
OUT TO TV
Y
COMPONENT OUT
(1080ii/720p/480p/480ii)
Pr
1
L2
R2R1
L1
2
AUDIO OUT
Pb
OPTICAL
DIGITAL
AUDIO
OUT
S VIDEO
OUT
VCR
CONTROL
(1080ii/720p/480p/480ii)
PHONE
JACK
VIDEO OUT
Phone wall jack
LNB
Sat B
LNB
Sat C
LNB
Sat A
Dish
5x4 Multi-switch*
Output
Antenna
Cable TV
wall jack
NOTE
While you are a subscriber to a DIRECTV
®
program package, you can still view over-the-air
and cable TV programs, if you make
connections to the over-the-air and/or cable jacks.
NOTE
A triple LNB multi-satellite dish with a SAT
C LNB is required to receive all DIRECTV
®
High-Definition programming, along with
this DIRECTV HD Receiver.