Dish Network 21.0 Universal Remote User Manual


 
4
4 For AUX mode only. Press
0 for a second TV, or 1 for a
second DVD/VCR, or 2 for
a tuner, amplifier, or audio
receiver.
This step is for programming
the kind of equipment that
should be programmed in AUX
mode. If you’re not
programming in AUX mode,
skip to step 5.
5 Enter one of the three-digit
equipment codes from the
table using buttons on the
number pad.
The three-digit equipment code
should be for the brand name of
your equipment that you found
in step 2.
6 If you want to program
Limited Mode, press 1.
If not, skip to step 7.
See Limited Mode on page 3 for
more information.
7 Press POUND (#). If you entered the code
correctly, the mode button
flashes three times.
8 Press POWER to turn off
the equipment. If the
equipment does not turn
off, go to step 10.
If the code you entered works,
the equipment should turn off.
9 Turn the equipment back
on and try some other
buttons to make sure they
work. If the code works for
other buttons, stop here.
For example, sometimes
POWER works when other
buttons don’t. Note that more
than one code may work to turn
equipment on or off.
10 If the code doesn’t work,
repeat steps 3 through 9
with another equipment
code listed in the tables.
Try every code listed for your
brand until one works for your
equipment.
11 If you can’t find a code that
works, try the instructions
that follow for Scanning
for Equipment Codes.
Instructions Additional Information