Filter
Top Products
10
5 Point the front of the original equipment’s remote to face the
small square (IR window) on the front, left-hand side of DISH’s
remote, as shown below and on page C-1.
6 On the DISH Network remote, press the button you want to teach.
7 On the original equipment's remote control, press and hold the
button you want learned. If the DISH Network remote learns the
command, the mode light blinks off and then back on.
If the mode light blinks three times or remains lit, the DISH
Network remote did not learn the command.
You may need to press the button on the original remote several
times for the DISH Network remote to learn the command.
8 After a button has learned a command successfully, repeat step 6
and step 7 until all commands you want have been learned.
9 To end the learning sequence:
• Press one of the mode buttons on the DISH Network remote.
This saves all the commands for that mode, and exits learning
to return to normal remote control operation.
• If the remote runs out of memory for learned commands, it
saves the commands you have learned for equipment in this
mode, exits learning and returns to normal remote control
operation. The DISH Network remote cannot learn additional
commands.
•If the remote control batteries are too low for
learning, all the mode buttons blink quickly eight
times. Learning ends without saving learned
commands, and the remote returns to normal
operation. Change the batteries.
•To cancel learning, do not press any buttons on
either remote control for at least 30 seconds. The DISH
Network remote control times out and returns to normal
operation.
Note that no learned commands are saved if the DISH
Network remote control times out before completion.
SAT
POWER
I
MENU
GUIDE
B
R
O
W
S
E
T
H
E
M
E
S
MUTE
RECALL
VOLUME
DVR
TV
VCR
AUX
TV
PAGE
CAN
INFO
VIEW TV