Filter
Top Products
7
PROGRAMMING THE REMOTE TO CONTROL A SECOND
R
ECEIVER IN AUX MODE
If you have another DISH Network receiver installed, you can use this
remote control in AUX mode to operate it along with your new
receiver. When you program the remote control to operate the other
receiver, the remote will send IR signals to that receiver, so the line of
sight to the second receiver must be unobstructed. You can program the
remote control to operate any other DISH Network receiver, except for:
• TV2 on DISH 322, DISH Player-DVR models 522, 625, and 942,
ViP222, ViP222k, ViP622 DVR, ViP722 DVR or ViP722k DVR
• DishPlayer 7100/7200
1 Turn on the other receiver and open the System Information
screen. (For help opening the System Information screen, refer to
the user guide for the other receiver.)
Write down the TV2 address shown:
2 Press and hold the AUX button until all the mode buttons light up,
and then release the button. The AUX button flashes.
3 Use the NUMBER PAD on the remote control to enter a 3,
followed by the address you wrote down in step 1.
4 Press POUND (#). The AUX button blinks three times.
5 Press RECORD to verify that the address in the remote control
now matches the address for the receiver.
M
AKE SURE THE REMOTE
CONTROLS THE AMPLIFIER’S
VOLUME IN OTHER MODES:
MAKE SURE THE REMOTE
CONTROLS THE TV’S VOLUME
IN OTHER MODES:
6 Press the SAT mode
button.
6 Press the SAT mode
button.
7 Press the plus (+) and
minus (-) sides of the
VOLUME button.
7 Press the plus (+) and
minus (-) sides of the
VOLUME button.
8 Your tuner/amplifier’s
volume changes and the
AUX mode button lights
instead of the TV mode
button.
8 Your TV’s volume changes
and the TV mode button
lights instead of the AUX
mode button.
Control Amplifier Volume Control TV Volume