EMC ATA TV DVD Combo User Manual


 
A-2
2-Gigabit Disk-Array Enclosure (DAE2) Hardware Reference
Technical Specifications
Enclosure Specifications
Technical enclosure specifications include power requirements, size,
drive, interface, and standards information.
Ac Power
Requirements
The input current, power (VA), and dissipation per DAE2 are based
on the requirements that a maximum DAE2 configuration places on
the power supplies and cooling system to provide internal regulated
power. Typical values will be less, depending on the number and
manufacturer of disk modules. These values represent either
the values for a single power supply line cord, or
the sum of values shared by the line cords of two power supplies
in the same DAE2, with the division between the line cords and
supplies at the current sharing ratio (approximately 50% each).
A failure of one of the two power supplies in the DAE2 results in the
remaining supply and cord supporting the full load. You must use a
rackmount cabinet with ac power distribution, and have main branch
ac distribution that can handle these values for each disk enclosure in
the cabinet.
*A fully configured DAE2 includes two power supplies, two LCCs, and 15 disk drives.
Description
Requirement DAE2 (Fibre Channel) DAE2-ATA
ac line voltage 100 to 240 Vac + 10%, single phase, 47 to 63 Hz
ac line current 4.0 A at 100 Vac, 1.6 A at 200 Vac 3.0 A at 100 Vac, 1.4 A at 200 Vac
Power consumption 400 VA(392 W) max (fully configured)* 300 VA (294) W) max (fully configured)*
Power factor 0.98 min at full load, low voltage
Heat dissipation 1.41 106 J/hr (1,330 BTU/hr) max * 1.06 106 J/hr (1,017 BTU/hr) max *
In-rush current 25 A max for 1/2 line cycle, per power supply at 240 Vac
15 A max for 1/2 line cycle, per power supply at 120 Vac
Startup surge current 15 Apk (10.6 Arms) max for 100 ms, at any line voltage
ac protection 10 A fuse in each power supply, both phases
ac receptacle type IEC320-C14 appliance coupler, per power supply
Ride-through time 30 ms min
Current sharing 60% max, 40% min, between power supplies