Filter
Top Products
List of Functions
35
Extended Menu
Sub Menu Function
Display You can make settings related to the projector's display.
Messages: You can set whether to display (On) or not display (Off) the source name when you change the input source, the colour mode name when
you change the colour mode, a message when no image signal is input, and so on.
Display Background
*
: You can set the screen status for when no image signal is available to "Black", "Blue", or "Logo".
Startup Screen
*
: You can set if the startup screen (the image projected when starting the projector) is displayed or not.
A/V Mute
*
: You can set the screen displayed during A/V mute as "Black", "Blue", or "Logo".
User's Logo
*
You can change the user's logo that is displayed as a background and displayed during A/V Mute. s p.60
Projection You can set from the following according to the way the projector is setup. s p.53
"Front" "Front/Ceiling" "Rear" "Rear/Ceiling"
You can change the setting as follows by pressing down the [A/V Mute] button on the remote control for about five seconds.
"Front"W"Front/Ceiling"
"Rear"W"Rear/Ceiling"
* When set to "Front/Ceiling" or "Rear/Ceiling", you cannot disconnect the power cable immediately because cool down is performed after the
power is turned off.
* When "User's Logo Protect" is set to "On" in "Password Protect", settings concerning user's logo cannot be changed. You can make changes after setting "User's
Logo Protect" to "Off". s p.27
For EMP-1715/1705 For EMP-1710/1700