Filter
Top Products
PAGE 19
FireBall™ SEi User’s Manual
VIDEO FORMAT (NTSC AND PAL)
FireBall SEi supports NTSC and PAL video format standards. Follow these steps to set the video format to match that of your video display:
If you have not setup and registered your FireBall...
1) Plug in and Power on your FireBall.
2) When the Red Light on the front panel is solid red, press the POWER button once to make it blue.
3) Using the remote control, Enter the corresponding sequence for your desired video format.
• 64706 = PAL-M, (o,g,p,0,m)
• 64766 = PAL-N (o,g,p,m,n)
• 64724 = PAL-BGHI (o,g,p,b,g)
• 64687 = NTSC (o,g,n,t,s)
4) The FireBall will reboot and the Red Light will start to flash once the 5 digit code is accepted. If the FireBall does not reboot, wait 5
seconds and try the code again.
...or if you have already setup and registered your FireBall:
1) Using your remote control, press the MUSIC button
2) Press the SETUP button
3) enter 8020
4) Press the DOWN arrow
5) Press the OK button
The FireBall should reboot. When the red light is solid red, follow these steps:
6) Press the POWER button once to make it blue.
7) Using the remote control, enter the corresponding sequence for your desired video format.
• 64706 = PAL-M, (o,g,p,0,m)
• 64766 = PAL-N (o,g,p,m,n)
• 64724 = PAL-BGHI (o,g,p,b,g)
• 64687 = NTSC (o,g,n,t,s)
8) The FireBall will reboot and the Red Light will start to flash once the 5 digit code is accepted. If the FireBall does not reboot, wait 5
seconds and try the code again.