Filter
Top Products
39
Normal Speed: Recording speed for continuous recording. The speed is limited by the maximum total
recording capacity of the DVR (displayed in the lower left corner) as allocated across all the installed
cameras. Changing the resolution will also effect the value (fps) which is displayed next to the field showing
the remaining image rate for all cameras. If this is a positive number, there is still recording capacity left. If
the numbe is negative, the maximum total image rate is exceeded by the displayed value. In this case you
may choose to reduce either image rate or recording resolution. Please make sure that the number is
positive before leaving the menu; otherwise you will see a dialogue saying “Total FPS exceed maximum
recording rate, discard changes!”, and all camera settings will be reset to factory default setting.
Note: If less than 8 (resp. 4) cameras are installed, it is recommended to uncheck the checkbox “Installed”
for the unused input signals, as even these may influence the calculation of the remaining image rate!
Event Speed: Recording speed for event recording. The speed is adjustable from 1 to 25 IPS. If more than
one camera requires simultaneous event recording, the available speed will be distributed among the
respective number of cameras.
Record Audio: Checkbox is without function for the ECOR 264 F2/D2 DVR series.
PTZ ID: When using a PTZ Camera, in order to control the camera from the DVR this ID must match the
RS-485 ID used by the connected camera. Click “On” to confirm selection, “Off” to cancel PTZ control for
this camera. When PTZ ID is ON, a drop down menu will appear; set the PTZ ID address used to control
this camera in that menu.
Apply To: This button can be used to copy the recording settings to other cameras. Select which
camera(s) you wish to copy to. "Select All" selects all cameras, “Unselect All” deselects all cameras. Click
“OK” to copy the settings or "Cancel" to exit without copying.