Filter
Top Products
EVERFOCUS ELECTRONICS CORPORATION
6
MAIN MONITOR:
T
his connector is used for the Main monitor display, a number of
different display modes may be selected for viewing. This output
must be used to display the menu settings.
MAIN
MONITOR
MONITOR OUT
INTERNAL
VIDEO
SW3
A
W
hen the machine is in Menu, Search or Copy mode, the internal Video is switched to Monitor Out, so that the user can view
full screen OSD. In other modes, the Video from multiplexer main monitor will be loop-through to the Monitor Out.
MONITOR
3
( Internal circuit )
4
CALL MONITOR:
T
his connector is used for the Call (secondary) monitor.
This monitor can only display full screen pictures.
VIDEO IN (1~4):
T
he BNC connectors of video input enable the system to receive the
signals from each camera through the 75 ohm coaxial cables.
VIDEO OUT (1~4): Sends the signals from each camera to other external devices
(loop out).
5
VIDEO In/Output
ALARM-OUTPUT: Normal Close Alarm output. In normal condition, this terminal is
shorted to the terminal of ALARM-COM. In alarm status, it is
open between ALARM-NC and ALARM-COM terminals.
ALARM-INPUT: Normal Open or Normal Close type alarm sensor input. The Alarm Input
can be selected as Normal Open or Normal Close input in the setup menu.
When an alarm occurs, alarm recording will automatically start.
6
A
larm Input
LAN Connector:
T
he RJ-45 LAN connector used to connect to a local area
network.
7
A
larm Input/ Output
LAN