EverFocus EDSR400H DVR User Manual


 
EVERFOCUS ELECTRONICS CORPORATION
69
¾ Once you have a straight through cable plug one end into the LAN port
on the back of the recorder and the other into the router.
¾ Now Log into the Everfocus DVR menu and using the jog dial from the
previous chapter go to the Network Setting Menu. (See page 28 for more
instructions)
¾ If you have a Linksys Router:
Assign an IP address of 192.168.001.050 to the DVR, a Subnet mask
of 255.255.255.000, and a default gateway of 192.168.001.001.
If you have a D-Link Router:
Assign an IP address of 192.168.000.050 to the DVR, a Subnet mask
of 255.255.255.000, and a default gateway of 192.168.000.001.
If you have a pre-existing LAN:
Go to a Computer on the pre-existing network and do the following:
o Go to Start, then Run and type cmd and click on OK.
Then hit enter, type ipconfig and press enter this will give you the
information you will need.
Use the prior step to assign an IP address. For example, if you got the
IP address from the computer of 192.168.002.101. Assign the DVR’s
IP address as 192.168.002.050. Now Copy the subnet mask and default
gateway information you got from the prior step off the computer to
the DVR.