Filter
Top Products
Press ENT to enter the next figure. Follow the instructions on LCD to do the button
test. After that, the system will do the self-test of SDRAM, the hardware connection
test and flash test. All test results will be shown on LCD. It is the easiest way to
know if the system can work well.
When the whole process finishes, LCD will show the message as follows.
Test finished
5.12.10 Load Default
On the above figure press ESC and t to enter the next figure. Load Default is to
make all changed settings recover to defaults.
12-10. Adv Setup
Load Default
Press ENT to enter the next figure. Use s t to confirm Yes or No.
Load Default
Config? Yes
π Ø Enter ESC
Holde ESC to exit
Page 45