Filter
Top Products
Chapter 1 Physical and Network Specifications 1-33
Method of Securing the Device Through a Hole in the Floor
FIGURE 1-26 Cabinet Stabilization Measure: Securing the Device through a Hole in the
Floor
1.2.5 Planning Your Network Connection
This section provides an overview for starting the SPARC Enterprise M8000/M9000
server network required for system startup and network connections.
For details on the connections, see the SPARC Enterprise M8000/M9000 Servers
Installation Guide.
1.2.5.1 Setup and Network Connections
The serial port of the eXtended System Control Facility Unit (XSCFU) is used for the
following purposes:
■ Connecting a local area network (LAN) port to the system administration
network
■ Monitoring the boot process
■ Changing the initial values of the system controller
The administration network connects the XSCFU to the system administrator's
management console. A direct connection can be used for this purpose. However,
the connection is usually one through a hub or switch specific to the system control
network. To initialize a LAN port, direct administration of the serial port must be
performed.
Change this board leg
(height adjustment leg) to the
"F6-DA6G" and tighten the
bolt from under the floor.
Bolt diameter: M20
Bolt length: 15 mm + floor
thickness
(Floor)
(Device)
Note: Consult with the com-
pany that constructed the
building because the length
depends on the structure of
the building.